![]() I had to take it apart and in doing so I realized that the entire watch insides were not quite lined up with the buttons. The first time I reassembled the watch the STOP/RESET button didn’t work. The Date, Day, and time are set: Time Set Troubleshooting If buttons don’t work Use the START/SPLIT button to increase the number, use the STOP/RESET button to decrease the number, use the MODE button to advance to the next setting and the SET/RECALL button for Done. The on-screen instructions are pretty good compared to digital watches of yesteryear. I held the back on tightly as I screwed them in: Squeezing the Back on Tightly While Reinstalling the 4 Back Screws Step 8: Set the Time With the top of the watch at the top, reinstall the back so the lettering imprinted in the back of the watch is right-side up: Reinstalling the Back Insert the gasket back into its channel as seen below: Back Gasket Reinstalled in Channel Step 7: Reinstall the back I completely removed the gasket and cleaned any debris off of it: Waterproofing gasket removed Then reinstall the battery door screw: Reinstalling the battery door screw Step 6: Reinstall the waterproofing gasketĬhances are, the rubber gasket that keeps water out of the watch will jump out of its channel when you take the back off. Start by hooking the top of the battery cover in its slot and then lay the battery cover down, centering it over the battery and lining up the hole where the screw will be inserted: Inserting Battery Door tab into Slot Lay the battery with the button end down like this with the positive (+) side up: New Battery Inserted Step 5: Reinstall the battery cover. #WATCH BATTERIES REPLACED HOW TO#Peal the battery cover off the battery and you will have something that looks like this (pardon the slightly out-of-focus image): How to Replace Timex Ironman Triathlon Batteries-Old Battery and Battery Cover Step 4: Insert a new battery into the watch. You do not want to remove the watch internals or you will make the job more difficult (like I did). The battery cover will stick to the battery because of that red sticker and when you lift up the battery cover the battery will lift out as well. The battery cover tucks in on the top edge so lift from the bottom side (the end where you removed the screw). Remove that screw: How to Replace Timex Ironman Triathlon Batteries-Battery Cover Screw There is one screw that holds a metal shield down over the battery. Gently Prying off the Back Step 3: Remove the battery cover screw and lift off the battery cover. #WATCH BATTERIES REPLACED DRIVER#I used a small flat screw driver and gently nudged up on the edge and the back popped up. There are springs the push on the back for the piezoelectric speaker so the back will want to come off. Unscrew the Four Back Screws Timex Ironman Triathlon-Four Back Screws Loosened Step 2: Remove the back. The screws are small so make sure to set them aside where you are not going to loose them. I have a set of precision screwdrivers like the set I have linked in the “Tools Needed” section and the smallest phillips screwdriver works fine. Step 1: Unscrew the four phillips screws on the back of the watch. How to Replace Battery on Timex Ironman Triathlon Watch Hardware My trusty Ironman Triathlon began getting dim on me about a week ago and then it was acting strangely–finally it went blank on me. These finger cots will keep that oil from transferring to the watch.How to Replace Timex Ironman Triathlon Batteries We recommend doing this because any dirt, oils or grease on your fingers can get on the movement and damage the inner workings of the watch if you touch it with your bare fingers. Once the back of the watch case is open, before you touch any part of the movement, you should put plastic finger cots on your fingers that might touch the watch movement.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |